Rope Marker - netting machines
This machine is suitable for measuring, marking and cutting ropes with diameter range from 8 to 25 mm. (1”)
Marking can be done with one or two different colours, to fit the different needs. The machine can mark ropes at regular or irregular spaces. Cutting operation is done at hot temperature and it is accurate and clean.
Special customer requirements could be analyzed.
The Model avaiable are:
| CM1 |   |
Measuring and cutting features |
| CM2 |  |
Measuring and Making features Mod. A single colour Mod. B double colours |
| CM3 | |
Measuring, marking and cutting features Mod. A single colour Mod. B double colours |
|
ROPE PROCESS TIME ON CM3/B
We have done some trials and following are the related process time which will give you an idea about the performance of the machine. No operator is needed during the working cycle. The test was made on twisted rope of 18 mm polysteel
|
Please Wait
Operator Screen
Every model is supplied with a programmable logic controller (PLC) and a friendly S/W - (see following screen)
 |
 |
 |
|
|
|
|
Cutting
 |
Angle cut |
 |
 |
Straight cut |
Technical data:
Transmission pulley and brake at 1800 mm height from the ground Powered pulley coated with rubber Idle pulley for pneumatic contrast Electronic meter with instrument for setting marking cycles Inerasable bicolors marker Rope feeding speed from 5 to 30 meters/minute Air compressor Knot sensor and rope end sensor Frame with locking feet and wheels Expandable to optional hot cutter system and smoke vacuum PC serial port Voltage: 220 - 240 Volts single phase |
|
||||||||||
|
||||||||||
|
||||||||||
|
||||||||||